We offer several variants of the deck preparation.
Based on a sent CAD file or template/model, we prepare panels ready for DIY installation.
When we receive CAD (dxf, dwg) files or templates we present our price quotation and following an approval we prepare the panels and send them to the address indicated in the purchase order.
When choosing VENDECK COCKPIT PANEL our clients are given the option to router their own pattern, logo or inscription.
In our shipyard
When a boat is delivered to our shipyard, it is carefully measured and then we prepare our price quotation. Following an approval, we prepare and install the panels.
During the time your boat is in the shipyard, other works may be performed on the boat like painting the bottom, installation of additional accessories, polishing the boat’s sides or other works. It is also possible to “hand over” your boat after the season and to collect is in spring, before the next season, clean and ready for sailing.
On the Client’s premises
We can take measurements, prepare templates and then we install panels on the deck.
It is a convenient but at the same time the most expensive form. Our fitter arrives at the indicated address and takes measurements. On this basis, we present our offer of deck preparation and when it is approved, panels are prepared and installed on the boat.
An estimate cost of the service may be calculated before arranging a fitter based on the price list.
We sell ready panels to be cut and installed by the client.
You may buy ready VENDECK COCKPIT PLANK sheets and trim them to a specific shape, as required, with a utility knife.
The sheets are covered with a self-adhesive layer of glue and covering the boat with the panels should not be difficult for anybody.
Do you need more information?
We will be pleased to answer all your questions.